Why all-in-one
A split system is a project. An all-in-one is a product.
Conventional commercial heat pump systems split the hardware across an outdoor unit, a separate tank and field-made piping — and push the hardest, most failure-prone work onto your site and your schedule. We moved all of that work into our factory.
Side by side
Where the two approaches diverge
The differences below are structural — they follow from where the system is assembled, not from any single component choice.
| Aspect | Conventional split system | EMOOOO all-in-one |
|---|---|---|
| Installation time | Days to weeks — piping, welding, wiring, vacuuming, charging, commissioning | Hours — position the unit, connect water inlet/outlet and power |
| On-site labor | Refrigeration technician + plumber + electrician, coordinated on site | A local plumber and electrician — no refrigeration license required |
| Refrigerant work on site | Field piping, vacuuming and charging — quality depends on the installer | None. Circuit sealed, charged and leak-tested at the factory |
| Failure points | Every field-made joint, flare and braze is a potential leak or fault | Factory-welded circuit, run-tested under load before packing |
| Commissioning | Requires a commissioning visit; settings tuned on site | Controller pre-configured; factory test record ships with the unit |
| Footprint & layout | Separate outdoor unit, tank, pump set and pipe runs to route and insulate | One enclosure, one plinth, short water connections |
| Responsibility | Component makers, installer and importer share — and dispute — the warranty | One manufacturer owns the whole system, one warranty path |
| Scaling up | Redesign piping and rebalance the system | Add another packaged unit in parallel |
Site work, start to finish
Four steps between delivery and hot water
This is the complete installation procedure. Most sites finish within a single working day, using local trades only.
Position the unit
Set it on a level concrete plinth or load-rated roof area. One lift, no assembly.
Connect water
Cold water in, hot water out. Two connections to the building system.
Connect power
Wire the supply to the integrated controller. Voltage configured to your market at the factory.
Switch on
The controller runs the heat pump and circulation automatically. Hot water on schedule from day one.
For distributors & contractors
What this means for your business
Sell a product, not a project
Packaged units quote like equipment, not like engineering works. Faster quotations, cleaner margins, shorter sales cycles.
Install with local labor
No refrigeration technicians to schedule. Your customers’ own plumber and electrician can complete the installation.
Fewer callbacks
The failure-prone work — piping, charging, leak testing — happened in our factory under process control, not on a rooftop.
Start a conversation
Tell us your project. We will size the system with you.
Share your application, daily hot water demand and destination market. Our export team replies with a configuration proposal and quotation — usually within one working day.